The system combines a pure sine wave inverter with a sophisticated battery charger with adaptive charging technology. Also compatible with lithium batteries. Two AC outputs. In case of lack of power from the dock or from the generator, the device takes over in inverter mode to power what is connected, without discontinuity.
The system combines a pure sine wave inverter with a sophisticated battery charger with adaptive charging technology. Also compatible with lithium batteries. Two AC outputs. In case of lack of power from the dock or from the generator, the device takes over in inverter mode to power what is connected, without discontinuity. The second output is available only in presence of AC source. Devices that could discharge the battery, such as boilers, should be connected to this output. Three-phase parallel function. Up to 6 units can be connected in parallel. It is possible to connect 3 units of the same type for three-phase current. Up to 6 sets of 3 units can be paralleled. Power control: The multiplus is very powerful and can draw a lot of power from the dock or generator. With the multicontrol panel (14.270.32) the power consumption can be controlled by setting a maximum limit. The multiplus, given the set limit, will only use the remaining energy to charge the batteries. Power assist: If for a short period of time a power peak is required, the multiplus will compensate for the insufficient power supply by drawing energy from the battery. When the load reduces, the surplus power is used to recharge the batteries. The microprocessor controlled charger has a 4-stage bulk-absorption-floot-storage charging system of the Phoenix/Skylla type. - Aluminium casing - Protections against short circuit, overload, battery too low or too high, high ripple frequency, etc.
